Bayport is a small river city south of Oak Park Heights, once called South Stillwater, that grew up around the window factory and the state prison on the flats along the St. Croix. Andersen, founded in 1903, has built its windows here for more than a century, and generations of the town's houses were built by people who worked there. The housing runs from 1900s story-and-a-halfs on the grid near the river to 1950s ramblers and a few 1990s streets up the hill, most on full basements with block or poured walls.
The flats by the river are the low ground, and the houses there have basements that sit close to the St. Croix's level in a high-water spring.
A Bayport call to this number goes to an independent local water damage provider who covers the river towns. The provider looks at the foundation before writing anything down.
A block basement on the flats that took water through the wall when the St. Croix was high in April is basement flooding cleanup, and the old finish materials come out to let the wall dry. A hillside rambler whose original pit quit in a storm is sump pump failure cleanup. A 1900s house with an uninsulated wall on the north side is where the kitchen line freezes, which is frozen pipe cleanup once it thaws.
Andersen has been the town's employer since it moved its operation to the Bayport riverfront early in the last century, and a fair share of the windows that a water damage crew works around in the St. Croix Valley came from the plant down the street. Rebuild permits go through Bayport's own city offices, and lots along the river carry the St. Croix riverway rules on top.
Call (651) 461-4569 and tell us what you see. We put you through to a local water damage provider serving Bayport.
Water pulled off the slab and out from under the carpet pad in a finished lower level, then the walls metered before any drywall comes off.
Cleanup after the pit overflowed in a storm or a power outage, with the water gone and the finished basement dried on readings.
A stained or sagging ceiling under an upstairs bathroom or an ice dam, drained, dried, and opened only as far as the meter says.
The wall, floor, and lower level a split supply line soaked during a January cold snap, pumped out and dried once the water is off.
Wet attic insulation, ceilings, and exterior walls dried after meltwater backed up behind an ice dam or hail opened the roof.
A tank that let go in a lower-level utility room and the carpet, drywall, and storage it soaked, extracted and dried.
Air movers and dehumidifiers set by moisture readings and run until framing, subfloor, and drywall reach their dry target.
Drywall, trim, carpet, and paint put back in a finished basement after the drying log shows the framing is dry.